Ceramic Grouting Service
Ceramic Grouting
WorkPaoo Epoxy Ceramic Grouting is hygienic, stain-resistant, 3 component epoxy resin-based grout with a high degree of resistance to chemical attack, abrasion, and impact. The cured grout does not transfer taints to food products, prevents the entry of bacteria or dirt and is easily maintained in a sterile condition. WorkPaoo Epoxy Ceramic Grouting is designed for grouting glazed tiles, mosaic, vitrified and fully vitrified tiles, ceramic tiles, industrial tiles, granites, marbles & other natural stones, etc.
Area of application
- Walls and Floors
- Toilet & Washroom
- Interiors and Exteriors
- Dry areas
- Showers
- Swimming Pools
- Heavily Trafficked Floors
- Hygienic Sterile Areas
- Kitchens and Cafeterias
Specification Of WorkPaoo Epoxy Ceramic Grout
- Hygienic and chemical resistant
- Stain and bacterial resistant
- Can be cleaned off in 30 minutes and up to 1.20 minutes after application
- Provides high strength and durable joints
- Suitable for submerged conditions
- Easy to be cleaned from tiled surface
- Suitable for joint width of 1 - 10 mm
- Available in a wide range of colors
Application Instructions
Before commencing grouting, the adhesive bed must be set. The joints must be clean of all adhesive residue, dust or debris. Lightly sponge the tile surface to remove dust & dirt. Movement Joints: These should be provided in accordance with: part 1 - 2 and may be filled with the appropriate flexible sealant. Intermediate floor joints should be reinforced with brass or stainless steel. Use stainless steel where hygiene is essential.
Chemicals Mixing Procedure
The entire contents of PART A is Hardener Liquide and PART B is Soft Liquide should be poured into a clean mixing vessel and mix to a uniform consistency. Slowly add PART C is Ceramics Powder until the required slump free smooth paste is obtained. Immediately pour the mixed grout onto the working area.
CLEANING: Tools and containers may be cleaned using water when the adhesive is still fresh. The hardened adhesive can be removed from tools mechanically.